Mk.X Devastator in 3D Printed Stainless Steel

with No Comments

The Department of Secret Projects Department has been hard at work! In collaboration with the Robotic Synthesis Division, they’ve developed a new Ray Gun variant – the Mk.X “Devastator.” This is the first drop of the new Mk.X design, which has 10 fins around the base, as well as 10 linear flutes along the fins for maximum surface area and heat dissipation. There are four flutes around the end of the muzzle, to reduce undesired spread of gamma rays during high RoF (rate of fire) conditions.

Due to the complexity of the design, these are 3D printed in stainless steel. There is some bronze content in these as well, so there are little hints of bronze as pictured below. They’re quite beefy at 18 grams each, the same as the copper machined Ray Gun beads and a fair bit heavier than the Ti machined (10g) beads.

The Mk.X “Devastator” Ray Gun in 3D Printed Stainless Steel are $85 each, shipped to US addresses. US buyers can purchase using the PayPal button below. Buyers outside the US can hit the PayPal button to purchase and then contact me for a USPS Priority shipping quote at – Typically this ends up being an additional $15-25 due to Priority International cost. Shipment overseas at via any method other than tracked Priority or Express is at the buyer’s risk.

*** SOLD OUT ***

Mk.X Devastator in 3D Stainless